Difference between revisions of "EAS-1 External Command Seat/ja"

Revision as of 19:24, 20 September 2014

EAS-1 コマンドシート
Command pod によって カーリントン・モデルロケット&製紙
接続サイズ		側面設置
コスト	(合計)	235.00
	(乾燥)	200.00
質量	(合計)	0.144 t
	(乾燥)	0.050 t
空気抵抗		0.05
耐熱温度		1200 K
耐衝撃性		6 m/秒
開発技術		実地研究
開発導入費		8 100
バージョンから		0.20
Part configuration		externalCommandSeat.cfg
定員	(max)	1
積載量		70 l

A Kerbal pilots a ship while seated in the EAS-1.

The EAS-1 External Command Seat is a Command Module for one Kerbal crew member during their mission. Unlike all others, this module is not a capsule, but a seat that can, for example, be attached to rovers. Thus it has no interior, integrated SAS module or electrical storage capabilities and has no pilot in it when the mission starts.

A seated Kerbal adds 0.09375 tons of mass to a vessel and may cause problems when steering small rockets or rovers.

Usage

This module is designed for rovers but can also be used to control any other kind of vessel.

To prepare it to control a vessel, move a Kerbal from a manned command pod into the seat by putting him on EVA, moving him close to the seat, and right-clicking it. As long as a Kerbal is sitting in the seat, it provides full command-module functionality, with the exception of doing crew reports (an EVA report can be conducted, however).

Vessels that are solely controlled by a seat must get a pilot from somewhere. Two ways to get one exist:

1. Launching just a manned command pod, putting the pilot on an EVA, walking him out of the launchpad area, and then launching the vessel with the seat.
2. Adding a crewed, detachable command pod to the vessel.

ゲーム内の説明

トリビア

• 側面取付方式のパーツであるため、司令ポッドでありながら機体中心パーツとして唯一設置することが出来ない。
• 他の司令ポッドとは異なり、着席してもEVAジェットパックの燃料補給が行われない。
• ヘルメットに物体が衝突するような強いせん断力が働くと、着席している緑を座席から引き摺り下ろすことが出来る。

変更点

0.20

• 実装。