Ablator

From Kerbal Space Program Wiki
Revision as of 01:50, 28 February 2017 by Benjamin Kerman (talk | contribs)
Jump to: navigation, search
Ablator
Density 1 kg/unit
Transferable No
Tweakable Yes
Drainable No
Flow mode Internal
Cost 0.5 Funds/unit
0.5 Funds/kg
Since version 1.0

Ablator is a resource that is a vital component of most heat shields. During atmospheric entry, ablator will slowly be consumed, dissipating heat in the process. Ablator can not be replenished or transferred between parts. If a heat shield runs out of ablator it will stop preventing overheating for shielded parts. Ablation shields work by allowing the material to burn away to dissipate heat. The exception to this is the Heat Shield (10m), which relies on drag to slow it down before overheating. As of version 1.2.2, an overheating bar shows up on ablative heat shields. This bar never reaches the point of explosion reentering at "sane" speeds, but will do so when ablator runs out or the entry is too fast or long.

Parts

Image Part Radial size Cost
(Funds)
Mass
(t)
Max. Temp.
(K)
Tolerance
(m/s)
Tolerance
(g)
Ablator
HeatShieldSmall.png
Heat Shield (0.625m) Tiny 150
(125)
0.075
(0.025)
3 300 9 50 50
HeatShieldSmall.png
Heat Shield (1.25m) Small 300
(200)
0.3
(0.1)
3 300 9 50 200
HeatShieldLarge.png
Heat Shield (2.5m) Large 600
(200)
1.3
(0.5)
3 300 9 50 800
HeatShieldHuge.png
Heat Shield (3.75m) Extra large 1100
(200)
2.8
(1.0)
3 300 9 50 1 800
Heat Shield (10m).png
Heat Shield (10m) Large / 10m 2 400 1.5 3 500
(3 250)
9 50


See also

Atmospheric entry#Ablative on Wikipedia