Difference between revisions of "Basic Fin"

From Kerbal Space Program Wiki
Jump to: navigation, search
m (Added detail.)
m (Fixed spelling)
Line 2: Line 2:
 
{{:Basic Fin/Box}}
 
{{:Basic Fin/Box}}
  
The '''Basic Fin''' is a part introduced in version 1.0.1. It is a very basic and small part, meant to partially stabilize small rockets early on in [[Career mode]]. It doesn't cost much, and therefore its not the best winglets out there.  It has a very low impact tolerance of 4 meters per second. It does, however, cause very little drag due to its small size.
+
The '''Basic Fin''' is a part introduced in version 1.0.1. It is a very basic and small part, meant to partially stabilize small rockets early on in [[Career mode]]. It doesn't cost much, and is not the best winglet out there.  It has a very low impact tolerance of 4 meters per second. It does, however, cause very little drag due to its small size.
  
 
== Product description ==
 
== Product description ==

Revision as of 20:41, 14 December 2015

This article is a stub. You can help KSP Wiki by expanding it.
Basic Fin
Part image
Winglet by
Jebediah Kerman's Junkyard and Spacecraft Parts Co
Cost (total) 25.00 Funds
Mass (total) 0.01000 t
Drag 0.02
Max. Temp. 934 K
Volume  ?
Impact Tolerance 4 m/s
Research Start.png Start
Unlock cost 0 Funds
Since version 1.0.1
Part configuration basicFin.cfg
Lift generated 0.12

The Basic Fin is a part introduced in version 1.0.1. It is a very basic and small part, meant to partially stabilize small rockets early on in Career mode. It doesn't cost much, and is not the best winglet out there. It has a very low impact tolerance of 4 meters per second. It does, however, cause very little drag due to its small size.

Product description

This simple bolt-on aluminum fin may not be the cutting edge of aerospace engineering but it's dirt cheap and will make your rocket slightly less unstable.

Changes

1.0.1
  • Initial release