Difference between revisions of "Basic Fin"

From Kerbal Space Program Wiki
Jump to: navigation, search
(Added basic content)
m (Added detail.)
Line 2: Line 2:
 
{{:Basic Fin/Box}}
 
{{:Basic Fin/Box}}
  
The '''Basic Fin''' is a part introduced in version 1.0.1. It is a very basic and small part, meant to partially stabilize small rockets early on in [[Career mode]]. It doesn't cost much, and therefore its not the best winglets out there.
+
The '''Basic Fin''' is a part introduced in version 1.0.1. It is a very basic and small part, meant to partially stabilize small rockets early on in [[Career mode]]. It doesn't cost much, and therefore its not the best winglets out there.  It has a very low impact tolerance of 4 meters per second. It does, however, cause very little drag due to its small size.
  
 
== Product description ==
 
== Product description ==

Revision as of 20:40, 14 December 2015

This is a stub. You can help KSP Wiki by expanding or discussing it.

This page was automatically generated by a bot.

Basic Fin
Part image
Winglet by
Jebediah Kerman's Junkyard and Spacecraft Parts Co
Cost (total) 25.00 Funds
Mass (total) 0.01 t
Drag 0.02
Max. Temp. 934 K
Impact Tolerance 4 m/s
Research Start.png Start
Unlock cost 0 Funds
Since version 1.0.1
Part configuration basicFin
Lift generated 0.12


The Basic Fin is a part introduced in version 1.0.1. It is a very basic and small part, meant to partially stabilize small rockets early on in Career mode. It doesn't cost much, and therefore its not the best winglets out there. It has a very low impact tolerance of 4 meters per second. It does, however, cause very little drag due to its small size.

Product description

This simple bolt-on aluminum fin may not be the cutting edge of aerospace engineering but it's dirt cheap and will make your rocket slightly less unstable.

Changes

1.0.1
  • Initial release