Difference between revisions of "Probe Control Point"

From Kerbal Space Program Wiki
Jump to: navigation, search
m (fixed grammar issue: "or a just a")
(command pod requires a kerbal)
Line 4: Line 4:
 
* At least 1 [[Pilot|Pilot]] on board (depends on the Command module, see table below)
 
* At least 1 [[Pilot|Pilot]] on board (depends on the Command module, see table below)
 
* Relay Antenna
 
* Relay Antenna
 +
 +
On the other side, the probe/ship must have the following :
 +
* A probe or command pod with the "remote pilot assist available" feature
 +
* If it's a command pod, a capable kerbal (scientist or engineer) must be aboard
 +
* Any antenna to establish the CommNet link
  
  
Line 24: Line 29:
  
 
A connection will be automatically established as soon as the probe gets within [[CommNet#Range_calculation|range]] of the Probe Control Point.
 
A connection will be automatically established as soon as the probe gets within [[CommNet#Range_calculation|range]] of the Probe Control Point.
 +
 +
While probes will automatically gain control, command pods need to have a capable kerbal (scientist or engineer, not a tourist) in order to gain the remote pilot's SAS ability.

Revision as of 17:52, 6 July 2019

A Probe Control Point is a specific vessel which allows you to control a probe without any connection to the KSC. In order to use a vessel as such a control point, some requirements need to be fulfilled:

  • Command module capable to function as Probe Controle Point
  • At least 1 Pilot on board (depends on the Command module, see table below)
  • Relay Antenna

On the other side, the probe/ship must have the following :

  • A probe or command pod with the "remote pilot assist available" feature
  • If it's a command pod, a capable kerbal (scientist or engineer) must be aboard
  • Any antenna to establish the CommNet link


The following table lists all Command modules which can be used to build a Probe Control Point, the required number of Pilots on board and whether it is possible to use additional relay satellites to establish a connection with the probe (Multi-Hop) or just a direct connection can be used (Single-Hop):

Command module Required Pilot(s) Link Type
RC-001S Remote Guidance Unit 1 Single-Hop
RC-L01 Remote Guidance Unit 1 Multi-Hop
Mk1-3 Command Pod 2 Single-Hop
Mk2 Lander Can 2 Single-Hop
Munar Excursion Module (Making History) 2 Single-Hop

A connection will be automatically established as soon as the probe gets within range of the Probe Control Point.

While probes will automatically gain control, command pods need to have a capable kerbal (scientist or engineer, not a tourist) in order to gain the remote pilot's SAS ability.