Difference between revisions of "Small Circular Intake"

From Kerbal Space Program Wiki
Jump to: navigation, search
(new page)
 
(added mention of common uses)
Line 2: Line 2:
 
{{:Small Circular Intake/Box}}
 
{{:Small Circular Intake/Box}}
  
The '''Small Circular Intake''' is a part introduced in version 1.0.5.
+
The '''Small Circular Intake''' is a part introduced in version 1.0.5. Due to its Tiny or Mk0 [[radial size]], it is commonly used in combination with the [[J-20 "Juno" Basic Jet Engine]] on small aircraft. It is also common in aircraft in early [[career]] mode due to its low science cost.
  
 
== Product description ==
 
== Product description ==

Revision as of 22:01, 2 February 2016

This article is a stub. You can help KSP Wiki by expanding it.
Small Circular Intake
Part image
Air intake by
C7 Aerospace Division
Cost (total) 250.00 Funds
Mass (total) 0.00700 t
Drag 0.3
Max. Temp. 1200 K
Volume  ?
Impact Tolerance 7 m/s
Research aviation
Unlock cost 3 000 Funds
Since version 1.0.5
Part configuration SmallIntake.cfg
Intake speed 15
Intake area 0.1 m2
Maximum intake air 0.5 Air unit

The Small Circular Intake is a part introduced in version 1.0.5. Due to its Tiny or Mk0 radial size, it is commonly used in combination with the J-20 "Juno" Basic Jet Engine on small aircraft. It is also common in aircraft in early career mode due to its low science cost.

Product description

A must-have for air breathing engines, this intake duct will pull in outside air to run turbine engines on, as long as there is any outside air to begin with, of course. Optimized for subsonic flight.

Changes

1.0.5
  • Initial release