Small Inline Reaction Wheel

From Kerbal Space Program Wiki
Revision as of 10:59, 12 February 2014 by XZise (talk | contribs) (!this part never hadn't SAS; -you;)
Jump to: navigation, search
Small Inline Reaction Wheel
Part image
Stability Augmentation System by
Found lying by the side of the road

Radial size Tiny
Cost (total) 600.00 Funds
Mass (total) 0.05 t
Drag 0.2
Max. Temp. 2000 K
Volume  ?
Impact Tolerance 9 m/s
Research Tech tree advanced flight control.png Flight Control
Unlock cost 3 200 Funds
Since version 0.7.3
Part configuration inlineReactionWheel.cfg
Pitch torque 5.0 kN·m
Yaw torque 5.0 kN·m
Roll torque 5.0 kN·m
Electricity required for torque
0.050
s·kN·m
SAS level × None

The Inline Reaction Wheel (previously named S.A.S Module) is a toggleable module that provides torque and SAS. It is one of the parts featured in the demo version of the game.

Description

The wheel adds assistive torque to a spacecraft, at the cost of electric charge

Unknown

Usage

The placement does matter for reaction wheels. Generally speaking they can cause some problems if placed far from the center of mass. Imagine you are grabbing that point and rotating it. That is what the reaction wheels will try to do. You'll get offcenter rotation anywhere other then near the COM.

comment by C7, in his blog entry “Updated Information on SAS in 0.21.1

They appear to function on a stability:mass ratio, and the effect can be enhanced by adding additional Inline Reaction Wheels. Often a single Inline Reaction Wheel isn't enough.

Each Inline Reaction Wheel adds 0.3 tons to the mass of your ship; if a lot of Inline Reaction Wheels are required to get a large ship off the ground, it should be considered to drop them with earlier stages when they are no longer needed.

Changes

0.21.1
  • Increased torque (3 → 20)
  • Mass decreased from 0.5 to 0.3
0.21
  • Renamed from “S.A.S Module” into “Inline Reaction Wheel”
  • Mass increased from 0.07 to 0.5
  • Costs electric charge
0.18
  • Retextured
  • (Undocumented) Mass reduced from 0.8 to 0.07, cost reduced from 2300 to 600
  • (Undocumented) Torque increased from 10 to 20, Ki/Kp/Kd changed from 1.0 / 3.0 / 5.0 to 0.0 / 5.0 / 3.5
0.11.0
  • (undocumented) SAS now use angular momentum instead of angular velocity - takes into account inertia momentum of the ship [1]
0.9
  • (undocumented) Tweaked Kd, Ki and Kp parameters
0.8.5
  • Exposed Kd, Ki and Kp parameters for tuning the SAS module
0.8
  • SAS toggle with 'T' key
0.7.3
  • Initial Release

Notes