Traveling to Moho
Traveling to Moho
- Length: 1-2 hours
- Difficulty: Moderate
- For Version: 1.0.4
- You may want to attempt to go to Eve before Moho to get a feel for high Delta-V capture burns.
Landing/ Return Stage
This stage can either have a 1.25, or 2.5m capsule on top, it all depends on your preference, but the engine should be a 2.5m engine. As Moho has very little gravity, it is quite easy to get off the surface. So this stage will be the smallest. To test your return stage, see if you can start on Minmus go to, and orbit the Mun and back to Kerbin, this will give you a rough estimate for the ammount of fuel you need to land saftly on Kerbin. Remember to place a heatshield on the bottom of your capsule!.
Moho Injection Stage
Kerbol Injection Stage
this stage should be similar to a second stage if you are going to Minmus. Large
This will be the biggest stage on your rocket.
Launching to Moho
This is a very routine launch, put you space craft in a rough 150 by 150 Km orbit.
This step is not very hard. Burn until your craft is in a Kerbol periapsis inbetween Moho and Eve. once you hit periapsis, bring your apoapsis down until you orbit is about circular inbetween Moho and Eve.
This is most likely the longest step. Wait until Moho is inbetween you and Kerbol, then burn Retrograde untill you get an incounter. Once you are near Moho periapsis, set up a manuver and get in orbit aroung Moho, it does not have to be circular. Congratulations, you have just got in orbit around Moho!
Landing on Moho
This is the same as landing on the Mun. If you do not know, go to apoapsis, burn retrograde until you are on a suborbital trajectory. Try to land on the light side of Moho. Just in case, put some Illuminator Mk1 or Illuminator Mk2 on your lander.