Difference between revisions of "Parts/FuelTank/mk2Adapters/standard.cfg"
From Kerbal Space Program Wiki
< Parts
m (BobBot moved page Parts/mk2SpacePlaneAdapter/part.cfg to Parts/FuelTank/mk2SpacePlaneAdapter/part.cfg without leaving a redirect: Update to new directory system) |
m (*update to 0.24.2;) |
||
| Line 27: | Line 27: | ||
subcategory = 0 | subcategory = 0 | ||
title = Mk2 to size 1 Adapter | title = Mk2 to size 1 Adapter | ||
| − | manufacturer = C7 Aerospace | + | manufacturer = C7 Aerospace Division |
description = This airframe fuselage features the latest in re-entry survivability. Apparently air gets very hot at high speeds (Who knew?!). To combat this, we attached only the finest in slightly used thermal tiles to the under belly. | description = This airframe fuselage features the latest in re-entry survivability. Apparently air gets very hot at high speeds (Who knew?!). To combat this, we attached only the finest in slightly used thermal tiles to the under belly. | ||
// attachment rules: stack, srfAttach, allowStack, allowSrfAttach, allowCollision | // attachment rules: stack, srfAttach, allowStack, allowSrfAttach, allowCollision | ||
| Line 51: | Line 51: | ||
} | } | ||
} | } | ||
| + | |||
}} | }} | ||
Revision as of 12:53, 12 August 2014
PART
{
// Kerbal Space Program - Part Config
// Fuselage Fuel Tank
//
// --- general parameters ---
name = mk2SpacePlaneAdapter
module = Part
author = C. Jenkins
// --- asset parameters ---
mesh = model.mu
scale = 1.0
// --- node definitions ---
node_stack_top = 0.0, 0.76, 0.0, 0.0, 1.0, 0.0
node_stack_bottom = 0.0, -0.76, 0.0, 0.0, 1.0, 0.0
// --- editor parameters ---
TechRequired = supersonicFlight
entryCost = 14600
cost = 550
category = Propulsion
subcategory = 0
title = Mk2 to size 1 Adapter
manufacturer = C7 Aerospace Division
description = This airframe fuselage features the latest in re-entry survivability. Apparently air gets very hot at high speeds (Who knew?!). To combat this, we attached only the finest in slightly used thermal tiles to the under belly.
// attachment rules: stack, srfAttach, allowStack, allowSrfAttach, allowCollision
attachRules = 1,0,1,1,0,0,1
// --- standard part parameters ---
mass = 0.1
dragModelType = default
maximum_drag = 0.2
minimum_drag = 0.3
angularDrag = 2
crashTolerance = 50
breakingForce = 50
breakingTorque = 50
maxTemp = 3000
fuelCrossFeed = True
RESOURCE
{
name = LiquidFuel
amount = 80
maxAmount = 80
}
}
