Difference between revisions of "Docking Port Drive"

From Kerbal Space Program Wiki
Jump to: navigation, search
(Notes)
(Added category.)
 
(2 intermediate revisions by 2 users not shown)
Line 8: Line 8:
 
Multiple z-Drives can be used in parallel, increasing the overall force.
 
Multiple z-Drives can be used in parallel, increasing the overall force.
  
While no direct keyboard/action group control method is yet known, the power of the force (up to the maximum value) can be precisely controlled through context menu of the docking port. One indirect method for toggling z-Drives has been to use an inflatable docking port, the extent of which is then bound to an action group, which only activates as a docking port when fully extended. Further indirect methods can use robotics to adjust the separation or orientation of the ports as a method of disrupting the drive power.
+
The power of the force (up to the maximum value) can be precisely controlled through context menu of the docking port. One indirect method for toggling or controlling z-Drives is to use an inflatable docking port, the extent of which activates and (once activated) modifies the force of the drive within a range, then deactivates the drive based on the distance of the port from its corresponding docking port. By binding the extension of the inflatable docking port to an action group it is thus possible to generate varied amounts of force.
 +
 
 +
reddit user u/dnbattley has demonstrated that, by duplicating a (n x grouping) junior docking port-inflatable docking port set up in an antagonistic pairing (i.e. in opposing directions), then binding their respective extensions to a KAL in an asymmetric manner, it is possible to use the mismatch of forces to generate a continuous and smoothly variable force from 0 to max which can be directly bound to the throttle.
 +
 
 +
Other indirect methods of control use robotics to adjust the separation or orientation of the ports as a method of disrupting the drive power, however these tend to be difficult to control accurately.
  
 
== Construction ==
 
== Construction ==
Line 21: Line 25:
 
== Notes ==
 
== Notes ==
 
https://www.reddit.com/r/KerbalSpaceProgram/comments/h0jf2k/surprisingly_balanced_emkracken_drive_in_stock/
 
https://www.reddit.com/r/KerbalSpaceProgram/comments/h0jf2k/surprisingly_balanced_emkracken_drive_in_stock/
 +
https://www.youtube.com/watch?v=o5E48mG4jZQ
 
https://www.youtube.com/watch?v=jsFcrnfzjh0
 
https://www.youtube.com/watch?v=jsFcrnfzjh0
 
<references />
 
<references />
 +
 +
[[Category: Exploits]]

Latest revision as of 11:19, 15 May 2021

The 'Docking Port Kraken Drive', z-Drive or zompi-Drive is a form of physics exploit which, alongside the other Kraken Drive and ladder drives which use phantom force-based exploits to propel or halt ships effectively forever, at no cost, out of stock parts.

Use and "operating modes"

A simple implementation of the "same-vessel docking port attraction". Note that both of the docking port attachment nodes are available for docking

Docking Port Drives are based on the attractive forces of docking ports. By facing two docking ports against one another, and adjusting the force of one port to increase relative to the other, a net force is generated as a vector from the higher force port towards the lower force port. This net force (which has been experimentally determined to be a maximum of around 9kN) can then provide an acceleration on the vessel. The gap between ports is a key factor in determining the force produced by the drive.

Multiple z-Drives can be used in parallel, increasing the overall force.

The power of the force (up to the maximum value) can be precisely controlled through context menu of the docking port. One indirect method for toggling or controlling z-Drives is to use an inflatable docking port, the extent of which activates and (once activated) modifies the force of the drive within a range, then deactivates the drive based on the distance of the port from its corresponding docking port. By binding the extension of the inflatable docking port to an action group it is thus possible to generate varied amounts of force.

reddit user u/dnbattley has demonstrated that, by duplicating a (n x grouping) junior docking port-inflatable docking port set up in an antagonistic pairing (i.e. in opposing directions), then binding their respective extensions to a KAL in an asymmetric manner, it is possible to use the mismatch of forces to generate a continuous and smoothly variable force from 0 to max which can be directly bound to the throttle.

Other indirect methods of control use robotics to adjust the separation or orientation of the ports as a method of disrupting the drive power, however these tend to be difficult to control accurately.

Construction

While it was initially believed that the drive required self-interaction, experimentation has determined this not to be the case. The distance required to maximise the force is approximately equal to the width of 4 structural plates. Both ports must have their port node "active", i.e. no parts must be attached to the open end.


Background

The first known mention of this effect is on a post made by 'u/74oshua' on reddit here z-Drives were first highlighted on the reddit channel by u/zompigespons (after whom the drive has been named) in August 2020. Unlike many of the physics exploits, z-Drives do not require self-interaction or any second vessel.


Notes

https://www.reddit.com/r/KerbalSpaceProgram/comments/h0jf2k/surprisingly_balanced_emkracken_drive_in_stock/ https://www.youtube.com/watch?v=o5E48mG4jZQ https://www.youtube.com/watch?v=jsFcrnfzjh0