Center of thrust

From Kerbal Space Program Wiki
Revision as of 19:41, 30 October 2014 by XZise (talk | contribs) (-you; *rewritten introduction (this is about the physical properties and not really about the other 'centers');)
Jump to: navigation, search
The thrust points away from the center of mass
This article is a stub. You can help KSP Wiki by expanding it.

The center of thrust (abbreviated COT) is the direction in which the thrust is acting and on which point the thrust is acting on. Because it has also a direction component it's usually called thrust vector. The COT and center of mass should be in one line to minimize steering losses. It is important to note that the COT is calculated based on all running engines on the craft and not just the engines in any individual stage. The center of thrust will change when engines get activated, deactivated or run out of fuel. Also when the craft's configuration changes, due to docking with other craft or jettisoning parts, the thrust vector will change.

Is one of the three “centers” displayed in the VAB and Spaceplane Hangar along with the center of lift and center of mass abbreviated COL and COM respectively.

Reading the Center of Thrust

The center of thrust is used mainly to determine a rockets' behavior in flight by comparing its position to the center of mass. It's basically the same as the center of lift but this is generated by engines rather than wings. If the COT is left of the COM then the rocket tilts right, to far right, and it tilts left. It behaves similarly if it is to far forward or backwards.

The COT should also be pointing at the COM as well, if it is pointing away from the COM then the rocket will be top-heavy and be prone to tilting. This is usually called pendulum rocket fallacy. In Kerbal Space Program such craft will be less efficient, as thrust vectoring needs to be applied to keep the craft pointing straight, and the thrust spent doing that is no longer available to push the rocket up like it normally would be. Steering problems can be fixed by adding engines with thrust vectoring, adding an RCS, or adding control surfaces.

See also