Difference between revisions of "Basic Fin"
From Kerbal Space Program Wiki
m (Added detail.) |
m (Fixed spelling) |
||
| Line 2: | Line 2: | ||
{{:Basic Fin/Box}} | {{:Basic Fin/Box}} | ||
| − | The '''Basic Fin''' is a part introduced in version 1.0.1. It is a very basic and small part, meant to partially stabilize small rockets early on in [[Career mode]]. It doesn't cost much, and | + | The '''Basic Fin''' is a part introduced in version 1.0.1. It is a very basic and small part, meant to partially stabilize small rockets early on in [[Career mode]]. It doesn't cost much, and is not the best winglet out there. It has a very low impact tolerance of 4 meters per second. It does, however, cause very little drag due to its small size. |
== Product description == | == Product description == | ||
Revision as of 20:41, 14 December 2015
| Basic Fin | ||
 | ||
| Winglet by Jebediah Kerman's Junkyard and Spacecraft Parts Co | ||
| Radial size | Radial mounted | |
| Cost | (total) | 25.00 
|
| Mass | (total) | 0.010 t |
| Drag | 0.02 | |
| Max. Temp. | 934 K | |
| Impact Tolerance | 4 m/s | |
| Research |  Start
| |
| Unlock cost | 0
| |
| Since version | 1.0.1 | |
| Part configuration | basicFin.cfg | |
| Lift generated | 0.12 | |
| Packed volume | 90 l | |
The Basic Fin is a part introduced in version 1.0.1. It is a very basic and small part, meant to partially stabilize small rockets early on in Career mode. It doesn't cost much, and is not the best winglet out there. It has a very low impact tolerance of 4 meters per second. It does, however, cause very little drag due to its small size.
Product description
| “ | This simple bolt-on aluminum fin may not be the cutting edge of aerospace engineering but it's dirt cheap and will make your rocket slightly less unstable. | ” |
Changes
- Initial release
