Difference between revisions of "Basic Fin"
From Kerbal Space Program Wiki
(Added basic content) |
m (Added detail.) |
||
Line 2: | Line 2: | ||
{{:Basic Fin/Box}} | {{:Basic Fin/Box}} | ||
− | The '''Basic Fin''' is a part introduced in version 1.0.1. It is a very basic and small part, meant to partially stabilize small rockets early on in [[Career mode]]. It doesn't cost much, and therefore its not the best winglets out there. | + | The '''Basic Fin''' is a part introduced in version 1.0.1. It is a very basic and small part, meant to partially stabilize small rockets early on in [[Career mode]]. It doesn't cost much, and therefore its not the best winglets out there. It has a very low impact tolerance of 4 meters per second. It does, however, cause very little drag due to its small size. |
== Product description == | == Product description == |
Revision as of 20:40, 14 December 2015
Basic Fin | ||
Winglet by Jebediah Kerman's Junkyard and Spacecraft Parts Co | ||
Radial size | Radial mounted | |
Cost | (total) | 25.00 ![]() |
Mass | (total) | 0.010 t |
Drag | 0.02 | |
Max. Temp. | 934 K | |
Impact Tolerance | 4 m/s | |
Research | ![]() | |
Unlock cost | 0 ![]() | |
Since version | 1.0.1 | |
Part configuration | basicFin.cfg | |
Lift generated | 0.12 | |
Packed volume | 90 l |
The Basic Fin is a part introduced in version 1.0.1. It is a very basic and small part, meant to partially stabilize small rockets early on in Career mode. It doesn't cost much, and therefore its not the best winglets out there. It has a very low impact tolerance of 4 meters per second. It does, however, cause very little drag due to its small size.
Product description
“ | This simple bolt-on aluminum fin may not be the cutting edge of aerospace engineering but it's dirt cheap and will make your rocket slightly less unstable. | ” |
Changes
- Initial release