Difference between revisions of "Mk1 Lander Can"
Mnethercutt (talk | contribs) m |
m |
||
| Line 5: | Line 5: | ||
== Usage == | == Usage == | ||
[[File:Mk1can panorama.jpg|thumb|left|Inside panorama view on [[Kerbin]]]] | [[File:Mk1can panorama.jpg|thumb|left|Inside panorama view on [[Kerbin]]]] | ||
| − | This is the smaller version of the [[Mk2 Lander-can]] which fits only a single Kerbal. Like the name suggests, it is useful for landers, because of the large window that allows a view to the outside and ground. The flat octagonal surfaces on the outside allow easy attachment of radial engines and/or landing gear. It is however very fragile, which makes landings after the potential loss of landing gear very risky. | + | This is the smaller version of the [[Mk2 Lander-can]] which fits only a single Kerbal. Like the name suggests, it is useful for landers, because of the large window that allows a view to the outside and ground. The flat octagonal surfaces on the outside allow easy attachment of radial engines and/or landing gear. It is however very fragile, which makes landings after the potential loss of landing gear very risky. It also has the lowest mass of any command pod in the game and as such is useful in situations where a lot of delta v is required. |
{{clear|left}} | {{clear|left}} | ||
Revision as of 16:35, 7 July 2014
| Mk1 Lander Can | |||||
 | |||||
| Command pod by Jebediah Kerman's Junkyard and Spacecraft Parts Co | |||||
| Radial size | Small | ||||
| Cost | (total) | 1 535.00 
| |||
| (dry) | 1 482.00
| ||||
| Mass | (total) | 0.660 t | |||
| (dry) | 0.506 t | ||||
| Drag | 0.2 | ||||
| Max. Temp. | 2000 K | ||||
| Impact Tolerance | 12 m/s | ||||
| Research |  Advanced Flight Control
| ||||
| Unlock cost | 6 800
| ||||
| Since version | 0.20 | ||||
| Part configuration | mk1LanderCan.cfg | ||||
| Crew capacity | (maximum) | 1 
| |||
| (required) | 1
| ||||
| SAS level | × None | ||||
| Torque | 3 kN·m | ||||
| Electricity required |
| ||||
| Experiment | Crew Report | ||||
| Collectable | No | ||||
| Rerunnable | Yes | ||||
| Resettable | Yes | ||||
| Electricity required | None | ||||
| Antenna type | Internal | ||||
| Antenna rating | 5 km | ||||
| Packed volume | None | ||||
| Inventory Slots | 1 slots | ||||
| Volume limit | 40 l | ||||
| Monopropellant | 15 
| ||||
| Electric capacity | 50 ⚡ | ||||
The Mk1 Lander Can is a Command Module housing one Kerbal crew member during its mission. It is designed for landing, and has a "down" looking window to facilitate such activities.
Contents
Usage
This is the smaller version of the Mk2 Lander-can which fits only a single Kerbal. Like the name suggests, it is useful for landers, because of the large window that allows a view to the outside and ground. The flat octagonal surfaces on the outside allow easy attachment of radial engines and/or landing gear. It is however very fragile, which makes landings after the potential loss of landing gear very risky. It also has the lowest mass of any command pod in the game and as such is useful in situations where a lot of delta v is required.
Description
| “ | This capsule was designed for lightweight non-atmospheric landers, and seats a single occupant. Features a novel full-body crumple-zone technology. — Jebediah Kerman's Junkyard and Spaceship Parts Co. |
” |
Trivia
- There's a photo of Kerbin hanging above the pilot.
- There are two sticky notes in the cabin:
| “ | Reminder: Close the hatch! — Over the control panel above you |
” |
| “ | Software glitch Update before flight — On the left side under some switches |
” |
- A pre-flight checklist is hanging on the right side of the cabin.
| “ | PRE-FLIGHT CHECKLIST [] Get permission to use ship — Pre-flight checklist |
” |
Changes
- Initial Release
