Difference between revisions of "M700 Survey Scanner"

Revision as of 23:06, 19 March 2017

This article is a stub. You can help KSP Wiki by expanding it. article

M700 Survey Scanner
Scanner by Experimental Engineering Group
Radial size		Small, Radial mounted
Cost	(total)	1 500.00
Mass	(total)	0.200 t
Drag		0.2
Max. Temp.		2000 K
Impact Tolerance		7 m/s
Research		Scanning Tech
Unlock cost		4 500
Since version		1.0
Part configuration		SurveyScanner.cfg
Mode		Orbital
Resource		All
Scanning time		5 s
Science bonus		10
Min. Altitude		25 000 m [1]
Max. Altitude		1 500 000 m [2]
Packed volume		None
↑ unless body radius / 10 is bigger ↑ unless body radius * 5 is smaller

The M700 Survey Scanner is an orbital low resolution resource scanner. It is used to map broad areas of resource concentration on a celestial body. It is the first step in finding locations which are rich in resources, for subsequent extraction. It provides a low detail overview of the entire celestial body, which can then be used to target specific areas for further detailed scanning with high resolution scanners (which can only scan a small area, not an entire celestial body).

Product description

Usage

as it deployed for operation...

The scanner works well on a small 1.25m satellite, but has a large electrical demand when activated, so a Z-1k battery, or equivalent, is recommended. The electrical demand is brief, so it is not necessary to have a huge generating capacity. It is not particularly heavy, so a FL-T200 fuel tank and LV-909 engine are quite adequate for the final stage, providing the necessary power to establish and adjust the orbit, either from LKO to Mun and Minmus, or entry from solar orbit to another system. An antenna is required to upload the data back to KSC, and any antenna will suffice.

Launching should probably make use of a payload fairing or cargo bay, as the scanner is large and not a good aerodynamic shape, so is likely to cause atmospheric control issues when placed on top of a rocket. The scanner requires a stable polar orbit at an appropriate altitude (see below). Once established in orbit, it must first be opened (Deploy Scanner), then the scan can be performed (Perform orbital survey). The scan is a once per body operation, and only takes a few seconds. The data acquired by the scanner is automatically transmitted, and it is the transmission which uses the large quantity of electricity. The scan result can be viewed in map mode (default M key) while controlling the scanner satellite, or from the KSC Tracking Station. To view the results in map mode, right-click on the scanner while it is deployed and select Toggle Overlay. To view the results from the Tracking Station, select the orbital body and then click on the Resources icon on the right hand side of the window. The deployed scanner can be retracted by clicking on the Retract Scanner option.

There are options to change the data presentation. You can modify the display cutoff value (the higher the value, the richer the deposit) and the results' color and style. You cannot change these parameters from map mode. Retracting the scanner will hide the results until the scanner is re-deployed and the overlay is toggled again.

After using this scanner, it is possible to start resource extraction based on its results alone, but the best results will be achieved by using the scan results as the basis for performing detailed, targeted scans with the high resolution scanners:

• Surface Scanning Module
• M4435 Narrow-Band Scanner

Scanning altitude

The scanner has a minimum and maximum scanning altitude based on the radius of the body it is scanning:

• The minimum altitude is one-tenth of the body radius or 25 km, whichever is higher.
• The maximum altitude is five times the body radius or 1.5 Mm, whichever is lower.

Power and time required

Changes

1.0

• Initial release